Installing Ruby 1.9 on Mac OSX
If you have ruby and a mac, no doubt you want to try out 1.9 - but be warned, some things can break! This little tutorial shows you how to install Ruby 1.9 in parallel to your 1.8.x installation… which can be handy…
Especially useful if you are developing an application in Ruby and want to test against 1.8.x and 1.9.
The goal here is to end up with a set of tools that can be 1.8 or 1.9 at will. The way I will do it is that you will end up with “ruby” and “irb” and “rake” and “gem” all pointing to your existing version of Ruby (be that 1.8.6 or 1.8.5 or whatever). Then you will get another set of tools like “ruby-trunk”, “irb-trunk”, “rake-trunk” and “gem-trunk” that will point to the 1.9 versions of these programs.
So, sound good? Great, enough talk, lets get started.
Getting Ruby
You can download Ruby 1.9 from http://www.ruby-lang.org/en/downloads/
Getting Read Line
You will most likely need Read Line 5.2 (Ruby 1.9 needs it), so you can get it from the readline GNU page
Installing ReadLine
Do the following from your home directory:
baci:~ mikel$ tar xvzf readline-5.2.tar.gz
baci:~ mikel$ cd readline-5.2
baci:~/readline-5.2 mikel$ ./configure --prefix=/usr/local/
baci:~/readline-5.2 mikel$ make
baci:~/readline-5.2 mikel$ sudo make install
This will make and install Read Line for you.
But if you are on Leopard, this might not work as planned, so replace the “make” above with:
baci:~/readline-5.2 mikel$ make static
baci:~/readline-5.2 mikel$ sudo make install-static
Thanks to Sean’s webblog for this tip.
Installing Ruby 1.9
Now you need to get Ruby working, you do this by doing the following:
baci:~ mikel$ tar xvzf ruby-1.9.0-0.tar.gz
baci:~ mikel$ cd ruby-1.9.0-0
baci:~/ruby-1.9.0-0 mikel$ ./configure --program-suffix=-trunk --with-readline-dir=/usr/local
baci:~/ruby-1.9.0-0 mikel$ make
baci:~/ruby-1.9.0-0 mikel$ sudo make install
Note the ./configure step? This is important because you are passing in two options, firstly you are telling it to add -trunk to the end of each program it makes (you could put anything you want here basically) and secondly you are telling it where to get ReadLine from on the system.
And that’s it!
To test, just try typing:
baci:~ mikel$ irb-trunk
irb(main):001:0> RUBY_VERSION
=> "1.9.0"
Enjoy!
blogLater
Mikel